50A 5-26V High Power MOS Trigger Switch Driver Module
Field Effect Tube PWM Regulation Electronic Switch Control
This highpower MOS trigger switch module handles 50A loads with 526V input. Using field effect transistor technology, it provides PWM regulation for heavy-duty electronic switching applications.
High Current Capacity - 50A continuous load handling
Wide Operating Range - 5V to 26V DC input
Use appropriate gauge wire for 50A connections
Add heatsink for loads above 30A
Do not exceed 50A current rating
Technical Specifications
| Parameter | Value |
|---|
| Load Current | 50A max |
| Input Voltage | 5V to 26V DC |
| Trigger Voltage | 3.3V to 24V |
| Control Method | PWM / Digital |
| MOSFET Type | N-Channel |
| On-Resistance | 4mΩ typical |
| Switching Speed | Microseconds |
= Key Features =
High Current Capacity - 50A continuous
Low OnResistance Minimal power loss
PWM Compatible - Speed and power control
Optocoupler Isolation - Protected input
Fast Switching - Microsecond response
= Applications =
- DC motor speed control
- Battery management systems
- Inverter switching
- Industrial equipment control
- Solar charge controllers
- Power distribution switching
Industrial Grade Reliable heavyload switching
Efficient Design - Low heat generation
√ Terminal blocks for secure wiring
√ Opto-isolated input protection
√ Status indicator LED
Connection Guide
Power connections:
- VIN+: Positive input (5-26V)
- VIN-: Input ground
- LOAD+: Load positive connection
- LOAD-: Load negative connection
- SIG: Trigger/PWM input
- SIG-: Signal ground
Use 10mm² cable for 50A
Mount on metal surface for cooling
Ensure tight terminal connections
Use proper fusing for protection
Wiring Requirements
Cable sizing for 50A:
- Minimum 10mm² copper wire
- Use heat-resistant insulation
- Keep cables as short as possible
- Use ring terminals for connection
Double-check all connections
Add fuse rated at 60A
Loose connections cause overheating
Use proper crimping tools
Control Methods
Digital control:
- Apply 5V for full on
- Apply 0V for off
- Fast switching capability
PWM control:
- Frequency up to 20kHz
- Duty cycle controls average output
- Smooth motor speed regulation
Simple Operation - Logic level trigger
Versatile Control - PWM for fine regulation
Used in industrial applications
Proven reliable design
√ Control input isolated from power
√ Works with Arduino and PLC
√ Reverse polarity protected
Thermal Management
Important for 50A operation:
- Active cooling recommended for high loads
- Use thermal paste between module and heatsink
- Monitor temperature during operation
- Derate current above 40°C ambient
Use fan for continuous high load
Mount with thermal compound for best transfer
Do not touch during operation
Allow cooling between heavy cycles
Protection Features
Built-in safeguards:
- Over-temperature shutdown
- Overcurrent protection
- Reverse polarity protection
- Gate drive protection
Safe Operation - Multiple protection layers
Reliable Design - Industrial components
√ Short circuit protected
√ Thermal shutdown included
√ Input isolation for safety
Troubleshooting
Module not switching:
- Verify trigger voltage
- Check power connections
- Avoid low trigger signal
Overheating:
- Add active cooling
- Reduce load current
- Avoid continuous max load
Voltage drop:
- Check cable gauge
- Verify connections tight
- Avoid undersized wiring
![12V DC 1/2" Male Thread Normally Closed Solenoid Valve – KSH 900 at HIMASTORES Mombasa – best electronics in Kenya](/uploads/12V SOLENOID VALVE 1.png "Buy 12V DC 1/2" Male Thread Normally Closed Solenoid Valve for KSH 900 – HIMASTORES Mombasa – Quality electronics in Mombasa, Kenya")
